Home
2 Getting Started with WBZ351 Curiosity Board
This section covers evaluation board features and running the preprogrammed demo example
2.2 Preprogrammed Demo Software

PIC32CX-BZ3

Introduction
1 Secure Boot and Signature Header Generation
2 Getting Started with WBZ351 Curiosity Board
This section covers evaluation board features and running the preprogrammed demo example
3 Getting Started with Software Development
This section gives a detailed information on the steps to install IDE, compiler, tool chain, BLE, Zigbee stacks and application examples on the PC.
4 Bluetooth Low Energy Applications
This section provides details on documentation describing the steps to test and develop the precompiled BLE application examples.
5 Getting Started with Zigbee Applications
6 Flashing hex from MPLAB DISCOVER using MPLAB IPE
This section provides a detailed procedure of how to download an already existing application hex file from MPLAB DISCOVER and flash the hex file into WBZ351 Curiosity Board using MPLAB IPE.
7 Adding Chip Peripherals
This section describes how to add analog/digital peripherals to the application
8 Low Power Design
This section explains in detail on how to enable the low power modes – Sleep/Standby or Deep Sleep/Backup modes in the design.
9 Firmware and OTA Updates
This section documents how to enable firmware updates in the design, whether it is serial or Over The Air (OTA)
10 Wireless System and Board Support Services
11 Application Timer Service
12 Support Documentation
This section has documentation that is generic and used as supporting document with the application example documentation.
13 Software API Guide
Microchip Information

2.2 Preprogrammed Demo Software

The WBZ351 Curiosity Board is equipped with pre-programmed software that demonstrates two commonly used BLE and Zigbee use case in a single application. These applications include BLE Sensor monitoring and BLE Lighting control.

The preprogrammed software implements a fully functional BLE Temperature sensor. The temperature sensor data from Curiosity's on-board temperature sensor is regularly read and can be accessed through advertising information which does not require a connection. In addition, the data is updated periodically after a BLE connection is established.

The pre-programmed software also implements brightness control of GREEN LED through BLE as well as through Touch slider/Button by connecting QT7 XPRO extension board. Once connected to mobile app through BLE, user can control the GREEN LED's brightness, and on/off state via BLE. Also, change the brightness using Touch slider. In addition, the ON/OFF state is made available via advertising information so that a user can know the status without connecting.