Jump to main content
BM70/71 Memory Programming User Guide BM70/71
Introduction
1 Quick References
1.1 Reference Documentation
1.2 Software Requirements
1.3 Acronyms and Abbreviations
2 Programmable Memory Overview
3 Memory Map of BM70/71
4 Command Protocols
4.1 General Format of HCI Command Packets (Host MCU to BM70/71 Module)
4.2 General Format of HCI-ISDAP Flash Commands (Host MCU to BM70/71 Module)
4.3 General Format of HCI Event Responses (BM70/71 Module to Host MCU)
5 Memory Programming Process Overview
6 Hardware Interface for Memory Programming
7 Modifying Configuration Parameters
8 Device Firmware Update Process Overview
9 HCI Commands Overview
9.1 HCI Command Packet – Read Buffer Size (Opcode – 0x1005)
9.2 HCI Command Packet – Host Buffer Size (Opcode – 0x0C33)
9.3 HCI Command Packet – Create Connection Command (Opcode – 0x0405)
9.4 HCI Command Packet – Disconnect Command (Opcode – 0x0406)
10 HCI-ISDAP Flash Commands Overview
10.1 Lock/Unlock Memory Command (HCI-ISDAP Opcode - 0x0100)
10.2 Read Memory Command (HCI-ISDAP Opcode - 0x0110)
10.3 Write Memory Command (HCI-ISDAP Opcode - 0x0111)
10.4 Write Continue Command (HCI-ISDAP Opcode – 0x0001)
10.5 Erase Memory Command (HCI-ISDAP Opcode – 0x0112)
10.6 Get Memory CRC Command (HCI-ISDAP Opcode - 0x0114)
11 HCI Event Responses
11.1 Disconnection Complete Event (Opcode – 0x05)
11.2 Connection Complete Event (Opcode – 0x03)
11.3 Command Complete Event (Opcode – 0x0E)
11.4 Command Status Event (Opcode – 0x0F)
11.5 Number of Completed Packets Event (Opcode – 0x13)
11.6 HCI-ISDAP Command Response (HCI-ISDAP Opcode – 0xXXXX)
11.7 Error Code Table Reference
12 Configuration Parameters
12.1 Name Fragment
12.2 HCI UART Baud Rate
12.3 RF Class
12.4 System Option 1
12.5 System Option 2
12.6 System Option 3
12.7 Power-on Standby Time
12.8 After Disconnect Standby Time
12.9 UART Transmit Indication (UART_TX_IND)
12.10 Check Receive Buffer Interval
12.11 Configure Timeout
12.12 Received Signal Strength Indicator (RSSI) Threshold
12.13 Connection Update Parameters
12.14 Advertising Timing Parameters
12.15 Battery Detection Parameters
12.16 Battery Voltage Detection Interval Parameter
12.17 Low Battery LED Flash Rate Parameter
12.18 General Purpose I/O (GPIO) Configuration
12.19 Advertising Data Structure
12.20 Passkey Value Parameter
13 Document Revision History
Microchip Information
The Microchip Website
Product Change Notification Service
Customer Support
Microchip Devices Code Protection Feature
Legal Notice
Trademarks
Quality Management System
Worldwide Sales and Service

The online versions of the documents are provided as a courtesy. Verify all content and data in the device’s PDF documentation found on the device product page.