2 Document Revision History

The revision history describes the changes that were implemented in the document. The changes are listed by revision, starting with the most current publication.


Revision	Date	Section	Description
B	01/2024	Document
		Overview	Added PIC32CX1012BZ24032/WBZ450-related information
		1 Silicon Errata Summary	Added PIC32CX1012BZ24032/WBZ450-related information Added new errata
		Silicon Errata Issues	Added PIC32CX1012BZ24032/WBZ450-related information Incorrect VDD Scaler Reference for AC_CMP0 Updated description and workaround Added note Wrong VDD Scaler Reference with CMP0 and CMP1 Enabled Concurrently Updated workaround Added note VIL Input Low Voltage Added note Programming or Debugging Updated workaround GPIO Output Configuration in Deep Sleep and Extreme Deep Sleep Updated workaround Added note CPU Hang Configuration Switch Updated description and workaround Added note Bus Error Address Checks Added note CFGCON0 Registers Added note TCC Outputs Added note TC Outputs Updated description Added note
B	12/2023	Silicon Errata Issues	Added new errata: Occurrence of Fetch Error Measurement Clock Stalls False Tamper Detection Reset of General Purpose Registers on Tamper Detection Reset of INTFLAG.TAMPER Bit Fails RTC SYNCBUSY Register Bits Not Cleared Unwanted Event and Interrupt Generation SERCOM-USART: INTFLAG.TXC being Set Incorrectly SERCOM-USART: Over Consumption in Standby Mode SERCOM-USART: Wake-up from Standby Sleep Mode SERCOM-I²C: Automatic Acknowledge Feature Not Usable SERCOM-I²C: Error Interrupt after Unexpected STOP SERCOM-I²C: 10-bit Addressing in I²C Client Mode SERCOM-I²C: Repeated Start Not Issued Correctly Counting-down Mode Not Supported in RAMP2 Hi-resolution in 2RAMP Mode LUPD in Descendent Mode TCC in Dithering Mode TCC in SYNC or RESYNC Mode Issues After Clearing STATUS.PERBUFV/STATUS.CCBUFx flag TC.PER not updated properly
A	10/2022	Document	Initial revision