PIC32CXMTx

5 Revision History

Revision C - 10/2025

The following updates were performed in this revision:


Document	Minor changes of format Compatible with Metrology Library version v03.04.00
Configuration	Add Interrupt threshold in Sag, Swell, and Interrupt section Updated Pulse Test Constant section Updated Creep (Start-up/No load) section Changed EMAFE section by AFE section and added subsections Removed reference in Other Features section
Calibration	Added D in CAL_M_Vx and note in Magnitude section Added CREEP_I_x, CREEP_P_x, CREEP_Q_x and first bullet in Application Sequence of Power Offsets and Creeps section
Metrology Firmware Special Function	Added D in CH_SEL_Vx in Waveform Capture section Added CH_VD_0 and CH_VD_1 in the table of Waveform Capture section
Monitor Metrology Firmware	Changed P_K_t, Q_K_t, and I_K_t by PULSEx_K_t in Monitor Metrology Firmware

Revision B - 04/2025

The following updates were performed in this revision:


Document	Minor changes of format Compatible with Metrology Library version 3.03.00 Changed Microchip Metrology data sheet by PIC32CXMTx Metrology Reference Guide (DS50003461)
Configuration	Added S_K_t in Pulse Test Constant section Added CREEP_THRESHOLD_S in Creep (Start-up/No load) section
Calibration	Updated Figure 2-1 Added note in Calculating Phase Calibration Factor Using Accumulator Values section Updated Power Offset section Added POWER_OFFSET_S in Single-Value Per-Cycle Power Offset Approach section Added Application Sequence of Power Offsets and Creeps section
Metrology Firmware Special Function	Updated Harmonic Analysis section

Revision A - 12/2022


Document	Initial release Metrology library version v3.0.0b

The online versions of the documents are provided as a courtesy. Verify all content and data in the device’s PDF documentation found on the device product page.