Introduction
1 Getting Started with WBZ451 Curiosity Board
This section covers the evaluation board features and running the preprogrammed demo example.
2 Getting Started with Software Development
This section gives a detailed information on the steps to install IDE, compiler, tool chain, BLE, Zigbee stacks and application examples on the PC.
3 Getting Started with Bluetooth Low Energy Applications
This section provides details on documentation describing the steps to test and develop the precompiled BLE application examples.
4 Getting Started with Zigbee Applications
- 4.1 Zigbee Project Generation
- 4.2 Zigbee Console Commands
- 4.3 Zigbee Commisioning Procedure
  Commissioning is the process of initializing the devices to join a network and to work together. The Zigbee Base Device Behaviour specification specifies the procedures for the following commissioning mechanisms which are executed in the order as provided below.
- 4.4 Zigbee Network Security Models
- 4.5 Zigbee Green Power
  Green Power is a feature of Zigbee, that allows for energy-harvesting technology to be used directly with the Zigbee stack. Green Power is the global wireless standard for large installations, when changing batteries and accessing devices becomes costly.
- 4.6 ZigBee OTA Sniffer
- 4.7 ZigBee Applications
  This section describes steps to test and develop the precompiled Zigbee application examples.
5 Getting Started with Multiprotocol Applications
This section describes steps to test and develop the precompiled BLE and Zigbee coexistence application examples.
6 Getting Started with IEEE 802.15.4 P2P Phy Application
7 Getting Started with IEEE 802.15.4 MAC Applications
8 Getting Started with Thread Applications
9 Adding Chip Peripherals
This section describes how to add analog/digital peripherals to the application
10 Flashing hex from MPLAB DISCOVER using MPLAB IPE
This section provides a detailed procedure of how to download an already existing application hex file from MPLAB DISCOVER and flash the hex file into WBZ451 Curiosity Board using MPLAB IPE.
11 Low Power Design
This section explains in detail on how to enable the low power modes – Sleep/Standby or Deep Sleep/Backup modes in the design.
12 Firmware and OTA Updates
This section documents how to enable firmware updates in the design, whether it is serial or Over The Air (OTA)
13 Wireless System Services API
14 Support Documentation
This section has documentation that is generic and used as supporting document with the application example documentation.
15 Software API Guide
16 Porting Guide
Microchip Information

4.6 ZigBee OTA Sniffer

This section provides details on how to configure and use supported sniffing tools along with Microchip MCU-based sniffer hardware platforms.

Introduction

In Zigbee® networking, a sniffing tool (for example, Wireshark Network Protocol Analyzer (Wireshark) is required to capture and analyze the frames exchanged in the network. This application note mainly focuses on the packet capture using the Wireshark.

ZigBee Packet Analysis Application Note

This application note provides details about the software requirements, hardware requirements and packet capture using the Wireshark. For more details on ZigBee Packet Analysis, refer to Zigbee Packet Analysis.