9.3.3 Preventing Flash/EEPROM Corruption

During periods of low VDD, the Flash program or EEPROM data can be corrupted if the supply voltage is too low for the CPU and the Flash/EEPROM to operate properly. These issues are the same on-board level systems using Flash/EEPROM, and the same design solutions may be applied.

A Flash/EEPROM corruption can be caused by two situations when the voltage is too low:
  1. A regular write sequence to the Flash, which requires a minimum voltage to operate correctly.
  2. The CPU itself can execute instructions incorrectly when the supply voltage is too low.
See the Electrical Characteristics section for Maximum Frequency vs. VDD.
Attention: Flash/EEPROM corruption can be avoided by taking these measures:
  1. Keep the device in Reset during periods of any insufficient power supply voltage. Do this by enabling the internal Brown-out Detector (BOD).
  2. The voltage level monitor in the BOD can be used to prevent starting a write to the EEPROM close to the BOD level.
  3. If the detection levels of the internal BOD do not match the required detection level, an external low VDD Reset protection circuit can be used. If a Reset occurs while a write operation is ongoing, the write operation will be aborted.