Introduction
1 Getting Started with WBZ451 Curiosity Board
This section covers the evaluation board features and running the preprogrammed demo example.
2 Getting Started with Software Development
This section gives a detailed information on the steps to install IDE, compiler, tool chain, BLE, Zigbee stacks and application examples on the PC.
3 Getting Started with Bluetooth Low Energy Applications
This section provides details on documentation describing the steps to test and develop the precompiled BLE application examples.
4 Getting Started with Zigbee Applications
5 Getting Started with Multiprotocol Applications
This section describes steps to test and develop the precompiled BLE and Zigbee coexistence application examples.
6 Getting Started with IEEE 802.15.4 P2P Phy Application
7 Getting Started with IEEE 802.15.4 MAC Applications
- 7.1 Full Function Device Demo for Push Pull Star Application
- 7.2 Reduced Function Device Demo for Push Pull Star Application
8 Getting Started with Thread Applications
9 Adding Chip Peripherals
This section describes how to add analog/digital peripherals to the application
10 Flashing hex from MPLAB DISCOVER using MPLAB IPE
This section provides a detailed procedure of how to download an already existing application hex file from MPLAB DISCOVER and flash the hex file into WBZ451 Curiosity Board using MPLAB IPE.
11 Low Power Design
This section explains in detail on how to enable the low power modes – Sleep/Standby or Deep Sleep/Backup modes in the design.
12 Firmware and OTA Updates
This section documents how to enable firmware updates in the design, whether it is serial or Over The Air (OTA)
13 Wireless System Services API
14 Support Documentation
This section has documentation that is generic and used as supporting document with the application example documentation.
15 Software API Guide
16 Porting Guide
Microchip Information

7.1.2 FFD Project Verification

LED indications :

In the coordinator if the blue LED in RGB LED glows the coordinator is powered ON and ready.

In the FFD the following are the different LED combinations indicating the following activity:

Quick Green Flash of the RGB LED indicates the reception of data from the end device.
Quick Blue Flash of User LED indicates that queued data was sent from coordinator to end device.

Following logs is the output generated by the coordinator in the Push Pull Star application.