Preface
All documentation becomes dated, and this manual is no exception. Microchip tools and documentation are constantly evolving to meet customer needs, so some actual dialogs and/or tool descriptions may differ from those in this document. Refer to our website (www.microchip.com) to obtain the latest documentation available.
Documents are identified with a “DS” number. This number is located on the bottom of each page, in front of the page number. The numbering convention for the DS number is “DSXXXXXXXXA”, where “XXXXXXXX” is the document number and “A” is the revision level of the document.
Introduction
This document describes how to install, configure and use the MPLAB® Code Configurator (MCC) software tool during or before starting the development process of an embedded software application designed with PIC® microcontrollers.
Recommended Reading
This user's guide refers to MCC operation only. Other applicable documents are listed below. The following Microchip documents are available and recommended as supplemental reference resources:
- Release Notes for the MPLAB Code Configurator
- MPLAB X IDE User’s Guide