Introduction
1 Quick References
2 Secure Boot and Signature Header Generation
3 Getting Started with WBZ351 Curiosity Board
This section covers evaluation board features and running the preprogrammed demo example
4 Getting Started with Software Development
5 Getting Started with Bluetooth Low Energy Applications
This section provides details on documentation describing the steps to test and develop the precompiled Bluetooth® Low Energy application examples.
6 Getting Started with Zigbee Applications
7 Getting Started with IEEE 802.15.4 P2P Phy Application
8 Getting Started with IEEE 802.15.4 MAC Applications
9 Getting Started with Thread Applications
10 Wireless Made Easy Framework
11 Flashing hex from MPLAB DISCOVER using MPLAB IPE
This section provides a detailed procedure of how to download an already existing application hex file from MPLAB DISCOVER and flash the hex file into WBZ351 Curiosity Board using MPLAB IPE.
12 Adding Chip Peripherals
This section describes how to add analog/digital peripherals to the application
13 Low Power Design
This section explains in detail on how to enable the low power modes – Sleep/Standby or Deep Sleep/Backup modes in the design.
14 Firmware and OTA Updates
This section documents how to enable firmware updates in the design, whether it is serial or Over The Air (OTA)
15 Wireless System and Board Support Services
16 Application Timer Service
17 Support Documentation
This section has documentation that is generic and used as supporting document with the application example documentation.
18 Wireless Protocol Software and Libraries
19 Migration Procedures for SoC and Module
20 Document Revision History
Microchip Information

19.7 PIC32CX5109BZ31048 to PIC32CX5109BZ36048