Board Setup

Follow these steps to verify proper operation of the kit:

  1. 1.Unpack the baseboard, taking care to avoid electrostatic discharge.
  2. 2.Check the default jumper settings.
  3. 3.Connect the USB Micro-B cable to connector J16 (JLINK-OB).
  4. 4.Connect the other end of the cable to a free port of your PC.
  5. 5.Open a terminal (console 115200, N, 8, 1) on your Personal Computer.
  6. 6.Reset the baseboard. A start-up message appears on the console.