3.7.1 Introduction

After performing a few operations/performance tests, the kit, along with its details, can be saved as an XML file that consists of all or part of the following information:
  1. Transceiver Board Details.

  2. Transceiver Registers.

  3. Packet error rate test configuration properties.

  4. Packet error rate test results.

  5. Results from Continuous Recording of PER test.

  6. Energy Density Scan results.

If the saved kit was in "Paired" state, the above information will be saved for both the Host and Remote nodes. This file will be used to load the kit offline. The information in the XML file are similar to that of the kit. i.e., if a value of a property/register is modified from the UI but not written to the kit, then the property/register will have the previous value which was written, while saving kit.