29.5.9 LUT n Control B

Note:

SPI connections to the CCL work in Host SPI mode only.
USART connections to the CCL work only when the USART is in one of the following modes:
- Asynchronous USART
- Synchronous USART host

Name:	LUTnCTRLB
Offset:	0x09 + n*0x04 [n=0..5]
Reset:	0x00
Property:	Enable-Protected


Bit	7	6	5	4	3	2	1	0
	INSEL1[3:0]				INSEL0[3:0]
Access	R/W	R/W	R/W	R/W	R/W	R/W	R/W	R/W
Reset	0	0	0	0	0	0	0	0

Bits 7:4 – INSEL1[3:0] LUT n Input 1 Source Selection

These bits select the source for input 1 of LUT n.


Value	Name	Description
`0x0`	MASK	Masked input
`0x1`	FEEDBACK	Feedback input
`0x2`	LINK	Output from LUT[n+1] as input source
`0x3`	EVENTA	Event A as input source
`0x4`	EVENTB	Event B as input source
`0x5`	IN1	IN1 input source
`0x6`	AC1	AC1 OUT input source
`0x7`	ZCD1	ZCD1 OUT input source
`0x8`	USART1	USART1 TXD input source
`0x9`	SPI0	SPI0 MOSI input source
`0xA`	TCA0	TCA0 WO1 input source
`0xB`	TCA1	TCA1 WO1 input source
`0xC`	TCB1	TCB1 WO input source
`0xD`	TCD0	TCD0 WOB input source
`Other`	-	Reserved

Bits 3:0 – INSEL0[3:0] LUT n Input 0 Source Selection

These bits select the source for input 0 of LUT n.


Value	Name	Description
`0x0`	MASK	Masked input
`0x1`	FEEDBACK	Feedback input
`0x2`	LINK	Output from LUT[n+1] as input source
`0x3`	EVENTA	Event A as input source
`0x4`	EVENTB	Event B as input source
`0x5`	IN0	IN0 input source
`0x6`	AC0	AC0 OUT input source
`0x7`	ZCD0	ZCD0 OUT input source
`0x8`	USART0	USART0 TXD input source
`0x9`	SPI0	SPI0 MOSI input source
`0xA`	TCA0	TCA WO0 input source
`0xB`	TCA1	TCA1 WO0 input source
`0xC`	TCB0	TCB0 WO input source
`0xD`	TCD0	TCD0 WOA input source
`Other`	-	Reserved

The online versions of the documents are provided as a courtesy. Verify all content and data in the device’s PDF documentation found on the device product page.