5.5 Summary

The following table provides a brief overview on how RX/TX application-level test outputs are enabled in different products. For more details about each product, refer to the corresponding data sheet and user manual.
Table 5-1. Product Specific Test Mode Description
ProductsApplication Test Mode

ATA5780N

ATA5830N
  • Configure Bit 1 and Bit 2 in EEPROM address 0x0018 to select between the IDLEMode, RXMode, TXMode or PollingMode after system start.
  • Write in Bit 0 in EEPROM address 0x0018 to get the transparent function.
  • TX transparent signal is set according to the level at PC4.

  • Activate RX transparent output signals via EEPROM address 0x010C Bit 1 to Bit 4.

(Verify the right I/O configuration for desired functions)

ATA5831/2/3

ATA5781/2/3

ATA8510/5

ATA8210/5

ATA8710
  • Configure EEPROM address 0x0019 Bit 0 and Bit 1 to select between the IDLEMode, RXMode, TXMode or PollingMode after system start.
  • Transparent operation can be set via Bit 2 in EEPROM address 0x0019.
  • The used channel, service and path is configured in EEPROM address 0x001A.
  • TX transparent signal is set according to the level at PC4.

  • Activate RX transparent output signal via EEPROM address 0x00DD Bit 1 to Bit 4 service 0. For more details about the register description for other services, refer to the corresponding user manual.

(Verify the right I/O configuration for desired functions)

ATA5835

ATA5787
  • Configure EEPROM address 0x000E by writing to the Bit 0 and Bit 1 to select between the IDLEMode, RXMode, TXMode or PollingMode after system start.
  • Transparent operation can be set via Bit 2 in EEPROM address 0x000E.
  • The used channel, service and path is configured in EEPROM address 0x000F.
  • TX transparent signal is set according to the level at PC4.

  • Activate RX transparent output signal via EEPROM address 0x022E Bit 1 to Bit 4 service 0. For more details about the register description for other services, refer to the corresponding user manual.

(Verify the right I/O configuration for desired functions)

ATA5702
  • Write a short user Flash application code and configure the device to work in the transparent TXMode (ATA_rfTxStartTx_C).
  • TX transparent signal is set according to the level at PD4.