3.3 Camera Setup

To set up the camera, perform the following steps:

  1. Make sure the MPF200-ETH-SENSOR-BRIDGE board is powered OFF.
  2. Connect the IMX477 Camera module to J14 MIPI connector using the 22-pin to 22-pin camera cable, as shown in the following figure.
    Figure 3-2. Connecting the Image Sensor to the MIPI CSI-2 Port of the Sensor Bridge
  3. Insert SFP+ to RJ45 converter into the SFP cage on J5.
  4. Connect the Ethernet cable from the SFP+ RJ45 port to the Ethernet port on NVIDIA Jetson AGX Orin Developer Kit, as shown in the following figure.
    Figure 3-3. Jetson AGX Orin Developer Kit Callout
  5. Connect the 12V power adapter to the J25 power input port.
  6. To turn on the board, slide the switch SW1 to the ON position.