AN3588

6.4 MPBT Setup Note

In the MPBT (MP BOARD LEVEL TEST) window, select RF Meter from the left pane.

Specify the “RF CABLE LOSS” value based on the value obtained by the power calibration procedure. Perform the power calibration by measuring the RF T_x power difference between the conducted T_x power and MP RF T_x power on the test fixture.

Note: For more details, refer to Appendix A: Test Jig TX Power Compensation.

Figure 6-5. RF Cable Loss Settings in MPBT

The online versions of the documents are provided as a courtesy. Verify all content and data in the device’s PDF documentation found on the device product page.